User Manual

57
English
SH2 Owner’s Manual
* When an operation (such as saving or data transfer) is in progress, the display shows a sequence of flashing dashes.
* Press any button to exit from these message displays.
Communication with the USB flash drive has failed. Remove the USB flash drive and make the
connection again. If the message appears even when the USB flash drive is connected properly, the
USB flash drive may be damaged.
This USB flash drive is not supported on this instrument, or too many USB flash drives may have been
connected. Refer to “Connecting USB devices” (page 45) for information on the USB flash drive
connection.
The instrument is in Access Point mode and standing by for connection to an access point by WPS
(page 51). While this message is shown, you cannot operate the instrument.
A malfunction occurred in the instrument while it was standing by for connection to an access point by
WPS (page 51). Reconnect the UD-WL01 (sold separately) to the instrument and try to connect to the
access point by WPS again.
Message Descriptions