User Manual

Smart Device Connection Manual for Android
8
Automatic Setup by WPS
If your access point supports WPS, you can easily connect the instrument to access point by WPS,
without making settings, such as key input, etc.
NOTE
Check whether your access point supports WPS by referring to the owner’s manual for the access point you are using.
1 Press and hold the [WPS] button on the USB wireless LAN adaptor (UD-WL01) for
longer than three seconds to start WPS.
The LED lamp of the adaptor flashes.
2 Press the WPS button on your access point within two minutes after step 1 above.
When the connection to the wireless network is completed, the LED lamp of the UD-WL01 lights,
and then flashes during communication over the network. The necessary information is
automatically set, and the connection between access point and the instrument has been
completed.
NOTE
For details about the operations in the setting of the access point, read the owner’s manual for the access point you are
using.
If you cannot set by WPS, follow the instructions in “Displaying the networks in the wireless LAN and
connecting to the network” (page 9).
3 Proceed to step 6 on page 7 to connect the access point and smart device.
LED lamp
[WPS] button
Press the WPS button on your access point.