User Manual

Smart Device Connection Manual for Android
9
Displaying the networks in the wireless LAN and connecting to the network
You can connect the instrument to the network by selecting it in the wireless LAN setting display on the
instrument.
1 Display the networks in the wireless LAN setting display of the instrument.
NOTE
If no signal from the access point is received, the access point cannot be listed. Also, closed access points cannot be listed.
2 Connect the instrument to the access point.
From the networks listed on the display, select the desired one.
For a network with a lock icon ( ), you need to enter the password, and for the network without the
lock icon, you can connect the network only by selecting it.
When connection is done successfully, the connection status is shown on the display, and the icon
shown below appears according to the signal strength.
The connection between the instrument and the access point is complete.
If you cannot find the desired network on the display or you want to set by a method other than
described above, follow the instructions in “Manual setup” (page 9).
NOTE
The name of the function described above may differ or the function may not be supported depending on the instrument.
3 Proceed to step 6 on page 7 to connect the access point and smart device.
Manual setup
If you cannot find the desired network on the display, it may be a network with closed or non-disclosure.
In this case, you will need to manually input SSID, security and key settings for connection.
NOTE
About the confirmation and changes in the access point settings, refer to the manual of the access point.
NOTE
For more information on successively inputting the SSID, Security and Password on the display of the instrument, refer to the
Owner's Manual or the Reference Manual of your instrument.
1 On the wireless LAN setting display on the instrument, select “Other” network (or
Manual Setup), then input in succession these settings: SSID, Security and
Password.
2 Execute the connection operation on the instrument such as pressing the [Connect]
button.
The necessary information is automatically set, and the connection between access point and the
instrument has been completed.
3 Proceed to step 6 on page 7 to connect the access point and smart device.
If you cannot find the desired network on the display or you want to set by a method other than
described above, follow the instructions in “Direct connection by using a USB wireless adaptor”
(page 6).
Strong Weak