User Manual

10
Power Supply
The Silent Guitar can operate either with the power adaptor or batteries as its power source.
Make sure that the power is switched OFF on the Silent Guitar when preparing the power supply.
Powering with AC Current
Please purchase a power adaptor. (Compatible power adaptors: PA-3C, PA-130(A, B))
1.
Plug the adaptor’s DC output cable into the Silent Guitar’s DC IN jack, making sure the plug is
rmly inserted into the jack.
2.
Plug the AC adaptor into a convenient wall AC power socket.
WARNING
When using an AC adaptor, make sure you use only one of the following recommended adaptors (Rec-
ommended Adaptors: PA-3C, PA-130(A, B)). The use of any other adaptor may result in damage to the
instrument or cause re, etc. Please use with caution.
CAUTION
Battery power is automatically disconnected when the AC adaptor is connected. When the AC adaptor
is used, the batteries may leak. To prevent leakage we recommend that you remove the batteries from
the instrument. When the AC adaptor is used.
WARNING
• Always replace both batteries at the same time. Never mix new and old batteries, battery types/models,
or batteries from di󰀨erent manufacturers. Doing so can cause leakage, overheating, and rupture.
• Do not incinerate or dismantle the battery.
• When using NiMH batteries, take care not to damage the battery casing or poles when installing and
removing the batteries.
• If the battery leaks, avoid contact with the leaked uid. If the uid should come into contact with your
eyes, mouth, or skin, wash immediately with water and consult a doctor.
• Please observe all local laws, rules, etc. when disposing the batteries.
Using Batteries
1.
Press the release lever in the direction indicated
on the
battery case to release the lock, then pull out the battery holder.
2.
Install two AA alkaline or NiMH batteries into the holder
mak-
ing sure their polarities are aligned as shown in the illustration
inside the holder. (See illustration)
3.
Slide the battery holder into the battery case. Push rmly
until
the case locks in place.
l
When to Change Batteries
The triangles in the display ash alternately ( )
when battery power becomes low. Change the batteries as soon as
possible. The device may not operate properly due to the discharg-
ing characteristics of some NiMH batteries.
AA battery x2
Release Lever
Battery Holder