User Manual

19
Power Connection
Connect the supplied power cord to the rear panel
ACINconnector,thenconnecttheotherendtoan
AC outlet.
CAUTION
For safe operation, always connect the ground
wire.
AC IN connector
Power cord (supplied)
Rear Panel
Using the Effect Loop
UsetheEFFECTLOOPSEND/RETURNjacksto
connect an external effector.
(Diagram 1)
YoucanswitchtheEffectLoopON/OFFusingthe
includedfootswitch.(→page20)
* The external effects circuit is set to serial at
factory but can be switched to parallel using the
“THR HD_H Utility” application. (→ page 21)
* Never directly connect the EFFECT LOOP SEND
jack to the RETURN jack.
TheSEND/RETURNjacksontheTHR100HD are
stereo(TRS)withtheTipcarryingtheL/MONOsignal,
andtheRingcarryingtheRsignal(Diagram 2).
To connect different external effectors to the Tip
andtheRingseparately,useaninsertcable(sold
separately) as shown in Diagram 2, and connect the
effectors as shown in Diagram 3.
* To connect two external effectors as shown in
Diagram 3, use the “THR HD_H Utility” to set the
FX LOOP SEND and RETURN Serial Connection
modes to “Separate” (→ page 21).
IN OUT
Diagram 1 Diagram 2 Diagram 3
Effector
Amp I (L) Effector Amp II (R) Effector
Tipe (L): L/MONO
Ring (R): R
Sleeve (G): GND
Monaural phone jack
L R
L RL R