User Manual

12
Names And Functions
Rotate the knob clockwise to increase the
amount of each effect.
* Rotate the knob fully to the left to set the effect
OFF.
!2 DLY/REV
On the THR10/10X, or THR5, this selects one
of the four different effects; DELAY (delay),
DLY/REV (delay/reverb), SPRING (spring
reverb), and HALL (hall reverb).
On the THR10C, this selects one of the four
different effects; TAPE ECHO, ECHO/REV
(tape echo/reverb), SPRING (spring reverb),
and HALL (hall reverb).
On the THR5A, this selects one of the three
different effects; DELAY (delay), DLY/REV
(delay/reverb), and HALL (hall reverb).
Rotate the knob clockwise to increase the
amount of each effect.
* Rotate the knob fully to the left to set the effect
OFF.
* When DELAY or DLY/REV is selected, the TAP/
TUNER e button can be used to set the delay
time freely.
!3 GUITAR OUTPUT (THR10/10C/10X Only)
Adjusts the overall volume of the guitar
sound.
* This knob’s setting has no effect on the signal
delivered by the USB @0 output.
!4 VOLUME (THR5/5A only)
Adjusts the overall volume of the guitar
sound.
* This knob’s setting has no effect on the signal
delivered by the USB @0 output.
!5 USB/AUX OUTPUT (THR10/10C/10X only)
Adjusts the audio playback volume for audio
from the computer connected to the USB @0
jack or an audio device connected to the AUX
!8 jack.
!6 INPUT
This jack is used to connect a guitar to the
unit.
!7 PHONES
This a standard phone jack used to connect a
pair of stereo headphones to the unit. It can
also be used as a line out jack.
* Main speaker sound is muted when a connector is
inserted into the PHONES jack.
!8 AUX
This is a stereo mini phone jack used for
audio input from an external device such as
an MP3 player, etc.
* The signal received on the AUX input is not sent
to the USB @0 output.
!9 USER MEMORY (THR10/10C/10X Only)
Saves up to five sets of amp section control-
ler settings (GAIN, MASTER, BASS, MIDDLE,
TREBLE, EFFECT, DLY/REV). Press and
hold the number of the switch you want to
save your settings to (about 2 seconds).
The save operation is complete when the
memory number for the switch being pushed
appears in the LED display. Press one of the
numbered switches (less than 2 seconds) to
recall the saved settings.