user manual

7-21
ELECTRIC STARTING SYSTEM
ELEC
NOTE:
New
5 Nm (0.5 mkg)
NOTE:
5. Measure:
 brush length
a
Out of specification  Replace the brushes
as a set.
Min. brush length
5 mm
6. Measure:
 brush spring force
Out of specification  Replace the brush
springs as a set.
Brush spring force
7.65 X 10.01 N (0.780 X 1.021 kg)
7. Check:
 gear teeth
Damage/wear  Replace the gear.
8. Check:
 oil seal
Damage/wear  Replace the defective
part(-s).
EAS00772
Assembling The Starter Motor
1. Install:
 brush holder
1
Align the tab
a
on the brush holder with the slot
b
in the starter motor rear cover.
2. Install:
 starter motor yoke
1
 O-rings
2
 starter motor front cover
3
 starter motor rear cover
4
 bolts
Align the match marks
a
on the starter motor
yoke with the match marks
b
on the front and
rear covers.