user manual

7-37
SIGNALING SYSTEM
ELEC
Replace the neutral
indicator light bulb,
socket or both.
NO
YES
The wiring circuit
from the turn signal
switch to the turn sig-
nal light connector is
faulty and must re-
paired.
NO
This circuit is OK.
EAS00800
4. The neutral indicator light fails to come on.
1. Neutral indicator light bulb and socket
 Check the neutral indicator light bulb and
socket for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.
 Are the neutral indicator light bulb and socket
OK?
YES
 Set the main switch to “ON”.
 Set the turn signal switch to “ ” or “ ”.
 Measure the voltage (12 V) of chocolate
or dark green at the turn signal light con-
nector (wire harness side).
 Is the voltage within specification?
1
2
Replace the neutral
switch.
NO
2. Neutral switch
 Check the neutral switch for continuity.
Refer to “CHECKING THE SWITCHES”.
 Is the neutral switch OK?
YES
3. Diode
 Disconnect the starting circuit cutoff relay
from the coupler.
 Connect the pocket tester (Ω  1) to the
starting circuit cutoff relay terminals as
shown.
 Measure the starting circuit cutoff relay for
continuity as follows.
YES
Replace the relay
unit.
NO
Tester positive probe 
light green
Tester negative probe 
sky blue
1
2
Continuity
NOTE:
When you switch the “–” and “+” leads of the
digital pocket tester the readings in the above
chart will be reversed.
 Are the tester readings correct?
EAS00760
Tester positive probe 
sky blue
Tester negative probe 
light green
2
1
No
continuity