User Manual

- 7 -
Owner’s Manual
Tio1608-D2
English
PA_en_14 2/2
• Do not place the product in a location where it may come
into contact with corrosive gases or salt air. Doing so may
result in malfunction.
• Before moving the product, remove all connected cables.
Maintenance
• Remove the power plug from the AC outlet when cleaning
the product.
Handling caution
• Do not insert your fingers or hands in any gaps or openings
on the product (vents, panel, etc.).
• Do not rest your weight on the product or place heavy
objects on it.
NOTICE
To avoid the possibility of malfunction/damage to the
product, damage to data, or damage to other property,
follow the notices below.
Handling and maintenance
• Do not use the product in the vicinity of a TV, radio, or other
electric products. Otherwise, the product, TV, or radio may
generate noise.
• Do not expose the product to excessive dust or vibration, or
extreme cold or heat, in order to prevent the possibility of
panel disfiguration, unstable operation, or damage to the
internal components.
• Do not install in locations where temperature changes are
severe. Otherwise, condensation may form on the inside or
the surface of the product, causing it to break.
• If there is reason to believe that condensation might have
occurred, leave the product for several hours without turning
on the power until the condensation has completely dried
out, in order to prevent possible damage.
• Do not place vinyl, plastic or rubber objects on the product,
since this might cause alteration or discoloration of the
panel.
• Clean the product with a dry and soft cloth. Do not wipe
product surfaces with sodium hypochlorite, alcohol,
benzene, paint thinners, cleaning fluids, or a chemical-
impregnated wiping cloth, which could cause discoloration
or change surface characteristics.
Information
About copyrights
• Copying of the software or reproduction of this manual in
whole or in part by any means is expressly forbidden
without the written consent of the manufacturer.
Protection of copyright
• Do not use this product for any purpose that may infringe
upon the rights of any third party including copyrights, as
established by law in each country or region.
• Yamaha bears no responsibility for any infringement upon
third party rights that may occur as a result of using this
product.
About functions/data bundled with the
product
• This produ ct uses the Dante module provided by
Audinate.The Dante module used in this product can be
confirmed in Dante Controller.
For more information about the open source licenses used
for each Dante module, please visit Audinate's website.
https://www.audinate.com/software-licensing
• XLR-type connectors are wired as follows (IEC60268
standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-).
About this manual
• The illustrations and screens as shown in this manual are
for instructional purposes only.
• Yamaha Corporation makes no representations or
warranties with regard to the use of the software and
documentation and cannot be held responsible for the
results of the use of this manual and the software.
• The company names and product names in this manual are
the trademarks or registered trademarks of their respective
companies.
•Software may be revised and updated without prior notice.
About disposal
• This produ ct contains recyclable components.
When disposing of this product, please contact the
appropriate local authorities.
Yamaha cannot be held responsible for damage caused
by improper use or modifications to the product, or data
that is lost or destroyed.