User Manual

Table Of Contents

ACD1 Owner’s Manual

Operations that can be performed from the panel

The following operations can be performed from the ACD1’s front panel.

•For details, refer to the ACD1 Reference Manual.

• Before use, remove the transparent protective ﬁlm that was applied to the LCD prior to shipment from the factory.

Category Sub category Operation performed

1. Scene Recall Recalls a scene on the speciﬁed ampliﬁer.

Store Saves a scene for the speciﬁed ampliﬁer.

2. Amp Control Standby/On Switches the power of the speciﬁed ampliﬁer between On and Standby.

Mute Mutes or unmutes the channel of the speciﬁed ampliﬁer.

Attenuation Adjusts the channel attenuator value of the speciﬁed ampliﬁer. (PC-N and Tn

series only)

3. Output Monitor Displays the output level of the speciﬁed ampliﬁer.

4. Device Setup Device ID Speciﬁes the ACD1’s Device ID address.

Device Label Displays the name of the ACD1 assigned by Amp Editor.

Identify Blinks the “Identify” icon of the corresponding ACD1 in Amp Editor.

5. Utility Battery Displays the state of the ACD1’s internal backup battery.

Firmware Ver. Displays the ACD1’s ﬁrmware version.

LCD Backlight Selects whether the ACD1’s LCD backlight will be always lit (ON) or lit only during

operation (Auto OFF).

Panel Operation Restricts panel operations of the ACD1.

Scene Recall Speciﬁes whether scene recall from the ACD1’s panel is enabled (Enable) or dis-

abled (Disable).

EMG Scene Setup Speciﬁes the scene number that will be recalled when the EMG (Emergency) sig-

nal is received from an external controller.

Last Mem. Resume Speciﬁes whether the ACD1 will start up with the settings that were in effect when

the power was last turned off (ON) or whether it will start up by recalling the amp’s

scene number that was in effect when the power was last turned off (OFF).

Clock Setup Sets the date and time of the ACD1’s internal clock.

GPI Calibration Calibrates the [GPI IN] connector input voltage.

6. Network Setup IP Address Mode Selects whether the ACD1’s IP address will be set automatically from Amp Editor

(DHCP) or set manually (Manual).

IP Address Speciﬁes the ACD1’s IP address.

MAC Address Displays the ACD1’s MAC address.

IP Ctrl Port # Speciﬁes the port number used when controlling the ACD1 via Ethernet from an

external controller such as AMX/Crestron.

NOTE