User Manual

Function Buttons

TNR-i Quick Guide 6

Function Buttons

Functions

By holding one of the ten function buttons of the TNR-i and operating

the LED buttons you can change voices, change octaves, and apply a

variety of effects and variations to your performance.

This unique visual/tactile interface has been specifically designed to

allow intuitive, instantaneous operation of a variety of functions.

 Double-tapping the Function button is equivalent to holding it.

[L1] + LED buttons Changing Voices

You can select any voice from the 256 voices available in one quick

operation. When you touch and hold the [L1] button, vertical and

horizontal lines will light on the matrix, and the button at their

intersection corresponds to the currently selected voice. If you tap a

different LED button while these crossed lines are showing the

intersection will move to that button and the corresponding voice will

be selected.

 The Voice number and name will appear in the Display. The Voice number

corresponds to the vertical and horizontal button numbers.

 TNR-i has 253 Preset Voices and 3 User Voices.

[L2] + LED buttons Changing Note Length

Sets the length of the notes from the time they are triggered to the time

they decay to silence (the gate time).

While holding the [L2] button, slide your finger horizontally over the

matrix to move the lit vertical line to the desired setting. Moving the line

to the right increases the note length.

 Not available in the Push Mode.

The “L” function buttons The “R” function buttons

Touching the [L1] – [L5] or [R1] – [R5] function

buttons will call up the jog dial. You can use this jog

dial to set the value of the current function.

07/13

16/1616/01

01/1601/01

01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16

Matrix with voice number 07/13 selected.

Voice number (vertical/horizontal position)

Voice name