User Manual

Function Buttons

TNR-i Quick Guide 7

[L3] + LED buttons Changing Octaves

Sets the playback pitch in octave increments.

While holding the [L3] button, slide your finger vertically over the matrix

to move the lit horizontal line to the desired octave.

[L4] + LED buttons Changing Loop Points

Sets the loop playback range in the Score Mode.

While holding the [L4] button, slide your finger horizontally over upper

half of the matrix to move the loop start point indicator to the desired

point, and slide your finger horizontally over lower half of the matrix to

move the loop end point indicator to the desired point, as required.

 In the Random Mode this function sets the rotation direction and speed.

 Not available in the Draw, Bounce, Push and Solo Modes.

[L5] + LED buttons Changing Loop Speed

Sets the loop playback speed (the duration of the beats).

Four settings are available, set via the leftmost four columns on the

matrix: quarter notes, eighth notes, sixteenth notes, and thirty-second

notes.

While holding the [L5] button, tap a button in the corresponding

column.

 Not available in the Push Mode.

[R1] + LED buttons Switching Layers

Switches to a different layer.

While holding the [R1] button, slide your finger vertically over the matrix

to move the lit horizontal line to the desired layer.

Moving the line to the lowest row selects layer 01, the next row up is

layer 02, then layer 03, and so on up to layer 16.

Layer