User Manual

4
■ Setting up the Timpani
The TP-3100(EA) series features a folding design to
reduce the space required to store or transport the tim-
pani. Use the procedure described below when setting
up or storing the timpani.
3 Lower the pedal section until the large metal
washer shown in Fig. B aligns with the guide hole
shown in Fig. C and then tighten the lock bolt.
Tighten until the large metal washer shown in Fig.
B fits completely into the guide hole.
Transporting and Setting Up the Timpani
2 Gently lower the pedal section.
4 Lay the timpani on its side, grasp the leg lock bolt
handle and loosen the leg lock bolt.
5 Slowly extend the sliding leg then tighten the leg
lock bolt at the chosen length. Make sure that the
marks on the sliding leg are aligned with the slit
in the leg holder. The casters may not function
properly if the marks are misaligned. Make sure
the marks are properly aligned.
1 First make sure that the
casters are locked (Fig. A).
Then with the timpani posi-
tioned as shown in the illus-
tration below, use both
hands to loosen the left and
right side lock bolts. Loosen
the bolts until the large
metal washer comes out of
the guide hole. (Fig. B)
Loosen the lock bolts until the
large metal washer is fully visible.
Fig. C
Fig. B
Leg Lock Bolt
Lock Bolts
Guide Hole
Sliding Leg
Mark
Caution
Never place your fingers or foot into the mov-
ing parts or the space under the pedal or base.
Serious injury can result if fingers or feet be-
come pinched.
Fig. A
Lock
Slit
tp3100ea_en_om.6pm 08.2.5, 9:28 AM4