Owner`s manual

a Gap
TIP
The spark plug gap should be measured with a wire
thickness gauge and, if necessary, adjusted to specifi-
cation.
4. Install the spark plug.
TIP
If a torque wrench is not available when installing a
spark plug, a good estimate of the correct torque is
1/4–1/2 turn past finger tight. However, the spark plug
should be tightened to the specified torque as soon as
possible.
5. Install the spark plug cap.
– 26 –
a
760-001a
Spark plug inspection
The spark plug is important engine components, which
should be checked periodically.
1. Remove the spark plug cap and the spark plug.
2. Check for discoloration and remove the carbon.
The porcelain insulator around the center elec-
trode of spark plug should be a medium-to-light
tan color.
3. Check the spark plug type and gap.
Standard spark plug:
BPR4ES (NGK)
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Spark plug torque:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Carburetor adjustment
The carburetor is a vital part of the engine. Adjusting
should be left to a Yamaha dealer with the profession-
al knowledge, specialized data, and equipment to do
so properly.
7DA-F8199-12-B 2011.2.21 13:11 Page 26