User Manual

TP70 Owner’s Manual

As shown in the figures below, set up your drum pad on an electronic drum rack or a standard tom stand

(such as a product from the Yamaha WS series).

1. Take the TP70 drum pad q and the S wing bolt w from the package and lightly tighten the S wing

bolt w (by five or six turns).

2. Slide the drum pad q onto the hexagonal tom holder e from the rack or tom stand, and then

tighten the S wing bolt w to secure it in place.

The functions that the pad can perform will depend on which of your drum module’s trigger input jacks it

is connected to. A chart showing the pad functions available with various input jack types can be

accessed from the web site shown below.

https://download.yamaha.com/

Setting Up

CAUTION

If the wing bolt and other fasteners are not sufficiently tightened, your drum pad may fall, pos-

sibly causing injury. It is important, therefore, that you mount your pad securely on the drum

rack or stand. In addition, you should avoid placing your rack or stand on an uneven surface as

this may cause it to fall over, again increasing the risk of injury.

Pads & Trigger Input Jacks