User Manual

7EN
This instrument also features an EQ Adjustment mode. In this mode, you
can adjust the mid-range EQ of the Effect sounds to create tonal changes or
to reduce the acoustic feedback (or howling noise.)
Entering the EQ Adjustment mode
Press the Line Out Volume Control/TA switch and wait until the LED located
inside the sound hole starts flashing (approximately 5 seconds).
Exiting the EQ Adjustment mode
• Press the Line Out Volume Control/TA switch and wait until the LED
located inside the sound hole stops flashing (approximately 5 seconds).
• When the Line Out Volume Control/TA switch is not operated for approx-
imately 30 seconds, the status automatically changes from the EQ
Adjustment mode to the Normal mode.
Adjusting the mid-range EQ of the Effect sound
Turn the Line Out Volume Control/TA switch.
Turning the switch all the way to the right (clockwise) disables the EQ
adjustment.
Turning the switch to the left (counterclockwise) increases the amount of
EQ adjustment applied to the mid-range EQ of the Effect sound.
Saving the settings
The settings for the EQ Adjustment mode are saved automatically.
NOTICE
When exiting the EQ adjustment mode by connecting or disconnecting a cable
(to or from the Output jack) while in the EQ adjustment mode, the settings are
not saved. The TA settings previously saved are maintained.
EQ Adjustment mode