Owner's Manual

Setting the initial volume for when the unit is turned
on
Sets the initial volume when the unit is turned on.
Setup menu
“Sound” > “Volume” > “Initial Volume”
Settings
Off
Sets the level to the volume level of the unit when it last
entered standby mode.
On
Mute Sets the unit to mute the audio output.
-80.0 dB to +16.5 dB
(0.5 dB increments)
[0.5 to 97.0 (0.5
increments)]
Sets the level to the specified volume level.
Note
▪ This setting works only when the volume level is set lower than “Max Volume”. For details on “Max
Volume” in the “Setup” menu, see the following:
– “Setting the limit value of the volume” (p.123)
▪
For details on the scale of the volume display (dB unit or numeric value), see the following:
– “Setting the scale of the volume display” (p.144)
Adjusting the CINEMA DSP 3D effect level
automatically
Selects whether to automatically adjust the CINEMA DSP 3D effect level when the
volume is adjusted.
Setup menu
“Sound” > “Adaptive DSP Level”
Settings
Off Does not adjust the effect level automatically.
On Adjusts the effect level automatically.
Setting Virtual Surround Back Speaker (VSBS)
Selects whether to create Virtual Surround Back Speaker (VSBS) using the surround
speakers.
When VSBS is enabled, the unit creates VSBS when no surround back speakers are
connected.
Setup menu
“Sound” > “Virtual Speaker” > “VSBS”
Settings
Off Disables Virtual Surround Back Speaker (VSBS).
On Enables Virtual Surround Back Speaker (VSBS).
Note
▪ VSBS is effective only when 6.1/7.1-channel content is played back.
▪ VSBS, that is working with CINEMA DSP 3D, is not available when the straight decode mode or the direct
playback mode is enabled.
En
124