Owner's Manual

TROUBLESHOOTING
11 En
DAB reception
Problem Cause Solution
Cannot tune into any DAB
stations.
The initial scan operations were not
performed.
Perform the initial scan operations
(☞ P. 7).
There is no DAB coverage in your area. Check with your dealer or WorldDMB
Online at “http://www.worlddab.org” for a
listing of the DAB coverage in your area.
The DAB signals are too weak. Change the height or direction of the
antenna, or relocate the unit.
The initial scan operations
are not successful and “Not
found” appears on the DAB
information display.
The DAB signals are too weak. Change the height or direction of the
antenna, or relocate the unit.
There is no DAB coverage in your area. Check with your dealer or WorldDMB
Online at “http://www.worlddab.org” for a
listing of the DAB coverage in your area.
The DAB station reception is
weak.
The DAB signals are too weak. Change the height or direction of the
antenna, or relocate the unit.
There is noise interference
(e.g. hiss, crackle or jitter).
The antenna needs to be repositioned. Change the height or direction of the
antenna, or relocate the unit.
The DAB signals are too weak. Change the height or direction of the
antenna, or relocate the unit.
The DAB station information
does not appear or is
inaccurate.
The DAB station may be temporarily out
of service, or the DAB station
information is not provided by the DAB
broadcaster.
Contact the DAB broadcaster.
FM reception
Problem Cause Solution
Too much noise during
stereo broadcast.
The antenna needs to be repositioned. Change the height or direction of the
antenna, or relocate the unit.
The FM station you selected may be far
from your area, or the FM wave
reception is weak in your area.
Try manual tuning to improve the signal
quality (☞ P. 9).
FM wave reception is weak.
(Sound is distorted.)
Multipath reflection or other radio
interferences may have occurred.
Change the height or direction of the
antenna, or relocate the unit.
Remote control
Problem Cause Solution
The remote control does not
work properly.
The remote control may be operated
outside its operation range.
For information on the remote control
operation range, refer to “Using the remote
control” (☞ P. 1).
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
Change the lighting or orientation of the
unit.
The battery may be worn out. Replace the battery with a new one
(☞ P. 1).
There are obstacles between the sensor of
the unit and the remote control.
Remove the obstacles.