User Manual

ADJUSTING THE CLOCK

7 En

1 Set CLOCK to SET.

2 Set the time.

Set the time with PRESET.

•Press SNOOZE/SLEEP in step 2 to switch between

the 12 and 24 hour clock display.

• The “PM” indicator will be shown only when you

select the 12 hour clock display.

3 Set CLOCK to LOCK to complete.

At the time LOCK is set, it will be 00 second and

time count starts.

The time settings are lost about one week after unplugging

the unit.

• The antenna should be stretched out.

• If you use an outdoor antenna instead of the supplied antenna,

reception will be better.

• If radio reception is poor, change the height, direction, or

placement of the antenna.

• If you listen to an FM radio station while USB charging, noise

may interfere with the radio reception. In this case, disconnect

the USB cable from the unit.

Note

5 Pin the antenna where the best reception is obtained.

Connecting the AM antenna (U.S.A. and Canada models)

ADJUSTING THE CLOCK

• Place the antenna in a location with good signal reception.

• Signal reception may be inadvertently affected if a digital

device is located near the antenna.

Note

Assembling the AM antenna

Rear panel

Front panel

PRESET

Note