Owner's Manual

Connecting to a network manually

Wired network connection

For a wired network connection, connect a standard shielded twisted pair (STP) network cable (straight, category 5 or higher; sold

separately) to the NETWORK jack on the rear panel.

1 Press OPTION.

2 Select in the option menu.

Select Network route setting>Wired and follow the

instructions in the display to complete setup.

Note

• When a router that does not support DHCP is used, use Network

Config in the option settings to configure network settings (####).

• To configure your router’s subnet mask manually, apply the same

subnet used by this unit to all devices (####).

NETWORK

OPTION