Operation Manual

INSTRUMENT AND CONTROL FUNCTIONS
3-7
3
EAU41600
Seat
To remove the seat
Remove the nuts, and then pull the seat
off.
To install the seat
1. Insert the projections on the front
of the seat into the seat holders as
shown.
2. Place the seat in the original posi-
tion, and then tighten the nuts.
NOTE:
Make sure that the seat is properly se-
cured before riding.
EAU37490
Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
WARNING
EWA14190
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
1. Nut
1. Projection
2. Seat holder
U3P281E0.book Page 7 Monday, April 17, 2006 11:26 AM