User Guide
Table Of Contents
- Contents
- Notice
- Product Overview
- Charging and Powering
- Connections
- Wearing this product
- Operating this Product
- Settings
- Troubleshooting
- Read this first
- No sound can be heard
- Sound can only be heard from one earphone
- Power will not turn on
- The product cannot be charged
- Cannot connect to a Bluetooth device
- The product does not operate or play back
- The sound is distorted, noisy or choppy
- Restoring this product to factory defaults (Initialize / Reset)
- Problem Still Not Resolved (Customer Support)
- Appendix
Connections
Registering a Bluetooth device (pairing)
When first connecting this product to a Bluetooth device, follow the steps below to register (pair) this
product with that device.
1 Set this product to pairing mode.
First, remove the earphone (R) and wait until the LEDs are lit as shown in the illustration
below. Next, remove the earphone (L). The earphone (R) will enter pairing standby mode.
Blue
20 sec
Red Blue
Flashes alternately
NOTE
If both earphones are alternately flashing red/blue, they cannot be successfully registered (paired). Place both earphones
back into the charging case and take them out again.
2 Activate the Bluetooth function on the Bluetooth device.
A list of Bluetooth devices that can be connected will be shown.
18
Connections > Registering a Bluetooth device (pairing)