Service manual

CABLE ROUTING
SPEC
H Pass the rear turn signal light
lead (right) between the rear
frame and license bracket,
avoiding to be caught.
I Pass the rear turn signal light
lead (left) between the rear
frame and license bracket,
avoiding to be caught.
J Clamp the rear turn signal light
lead (left). After clamping, point
the surplus part to the inner side.
D Clamp the wire harness and rear
turn signal light lead (right). Point
the surplus part to the inner side.
E Cover the naked part of rear turn
signal light lead (right) with the
hose.
F Cover the naked part of rear turn
signal light lead (left) with the
hose.
G Clamp the wire harness and rear
turn signal lead (right).
A Clamp the handlebar switch lead
and front brake light switch lead
with a band.
B Clamp the throttle cables.
C Clamp the C.D.I. magneto lead
(2 leads), starter motor lead,
neutral switch lead, battery neg-
ative lead and pass them
through the frame gusset hole,
then point the surplus part to the
inner side.
–14–