Service manual

CABLE ROUTING
SPEC
O Clamp the handlebar switch lead
(left) and clutch switch lead.
P After clamping, cut where it is not
visible either from the top or the
rear.
K Clamp the thermo switch lead
coupler. After clamping, point
the surplus part to the inner side.
L Pass the C.D.I. magneto lead (2
leads) through the grommet
side.
M Place the cover to the corner of
rectifier/regulator.
N No special order is set for the
C.D.I. magneto lead (2 leads),
neutral switch lead, starter motor
lead and battery negative lead.
–15–