Operation Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-9
1
2
3
4
5
6
7
8
9
NOTE:
Skip steps 4–9 if the oil filter element is
not being cleaned.
4. Remove the oil filter element drain
bolt to drain the oil from the oil filter
element.
5. Remove the oil filter element cover
by removing the bolts.
6. Remove the oil filter element and
O-rings.
7. Check the O-ring for damage and
replace it if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
NOTE:
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts and the drain
bolt, then tightening them to the
specified torques.
NOTE:
Make sure that the O-rings are properly
seated.
10. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
1. O-ring
2. Compression spring
3. Strainer
3
2
1
1. Oil filter element drain bolt
2. Oil filter element cover
3. Oil filter element cover bolt
1. Oil filter element
2. O-ring
1
2
3
1
2
2
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0m·kgf,
7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0m·kgf,
7.2 ft·lbf)
✹✺✬✲✥ ✬  