User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Amp Editor Owner’s Manual
146
Chapter
10
Component editor (TXn only)
When you click a component that has been placed in the Signal Path View window, the component editor
window will open. The component editor allows you to edit detailed parameters for the component.
Objects in the window and their function
• The content of the window as well as the name shown in the title bar will depend on the type of compo-
nent.
Title bar
Shows the name of the component.
Snap
This lets you temporarily store up to four parameter sets for the component editor (page 153).
Click a button to switch parameter sets. You can copy a parameter set by dragging and dropping a button onto
another button. You can also copy a parameter set by using the context menu that appears when you right-
click a button.
Knob
Drag a knob to edit its parameter. The mode of knob operation will depend on the “Preferences” dialog box
setting [Component Editor] tab [Knob Mode] (page 39).
• To make fine adjustments, drag while holding down the <Shift> key when [Knob Mode] is [Linear].
To reset a parameter to its default value, hold down the <Ctrl> key and click.
Title bar
Snap
Edit box
Knob
Button
NOTE
NOTE