User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
152
Context menu
The context menu that appears when you right-click in the window will differ depending on whether you’re in
Operation mode or Design mode. It will also differ depending on whether you’re in the component editor or the
custom control panel, and on the location at which you click.
 The context menu in Operation mode
Some of the commands shown in the Operation mode context menu are also shown in Design mode.
 [Design Mode]
Switches between Design mode and Operation mode. When you’re in Design mode, a check mark is shown at
the left of the command name.
 [Peak Hold]
Turns the level meter’s peak hold on/off and resets it.
 [On]
Selecting this will add a check mark, and peak hold will be turned on. Selecting this when a check mark is
already shown will turn peak hold off.
The peak hold on/off setting is valid only within Amp Editor.
 [Reset]
Resets peak hold.
• Peak Hold is a function that causes the maximum signal level value to remain visible.
 [Level Meter Enable]
Specifies whether the level meters will be enabled.
 [Add Parameter to Parameter Link] (only when you right-click on a control)
Allows you to create a parameter link group, or to add the parameter of the right-clicked control to a group
(page 161).
 [Add Component to Component Link]
Allows you to create a component link group or to add a component to a group (page 161).
 [Open Parameter Link]
Opens the “Parameter Link” dialog box (page 163). Here you can view or edit the status of parameter link.
NOTE