Operation Manual

CDI MAGNETO
4-70
2. Install:
• Woodruff key 1
• Rotor 2
NOTE:
• Clean the tapered portions of the crankshaft
and rotor.
• When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
• When installing the rotor, align the keyway c
of the rotor with the woodruff key.
3. Install:
• Plain washer 1
• Nut (rotor) 2
T 53 Nm (5.3 mdkg, 38 ftdlb)
Use the rotor holding tool 3.
Rotor holding tool:
YU-1235/90890-01235
A
4. Adjust:
• Ignition timing
Ignition timing:
2.4 mm (0.094 in)
a
Refer to “IGNITION TIMING CHECK” sec-
tion in the CHAPTER 3.
5. Connect:
• CDI magneto lead 1
Refer to “CABLE ROUTING DIAGRAM”
section in the CHAPTER 2.
ENG