User Guide

Using the UR22mkII
UR22mkII Operation Manual 12
Configuring Audio Driver Settings
on the DAW Software
This section provides examples of connecting the
UR22mkII to a computer. The explanations in this
section assume that the Yamaha Steinberg USB
Driver has been properly installed according to the
“Getting Started” instructions included with the
package.
Cubase Series Programs
1. Make sure that all applications have been
closed.
2. Launch the Cubase series DAW.
3. When the [ASIO Driver Setup] window
appears while the Cubase series program is
launching, confirm that the UR22mkII is
selected, then click [OK].
The audio driver settings are now complete.
Programs other than Cubase Series
1. Make sure that all applications have been
closed.
2. Launch the DAW software.
3. Open the audio interface settings window.
4. (Windows only) Select the ASIO Driver for
the audio driver settings.
5. Set the ASIO Driver for Windows and audio
interface for Mac as follows.
Windows
Set the ASIO Driver settings to [Yamaha Steinberg USB
ASIO].
Mac
Set the UR22mkII to the appropriate audio interface
settings.
The audio driver settings are now complete.
Recording/Playback
This section explains simple recording/playback
operations for using a microphone and an electric
guitar, using an existing template in Cubase (default
settings).
Cubase Series Programs
1. Launch the Cubase series DAW.
The [steinberg hub] window appears.
2. Select a project template in [Recording],
then click [Create].
The following example uses the [Clean E-Guitar +
Vocal] template. This template already includes some
tracks for recording a clean electric guitar and vocals.
NOTE
• If the [Missing Ports] window appears, select a
UR22mkII port for each [Mapped ports].
• Check [Map Always], and then click [OK]. By
checking [Map Always], the [Missing Ports]
window will not appear again.
3. Select [Devices]  [VST Connections] and
open [VST Connections] window.
Sets the input/output between Cubase and UR22mkII.