User's Manual

7-17
-+
ELEC
EAS00757
TROUBLESHOOTING
The starter motor fails to turn.
Check:
1. main, signal and ignition fuses
2. battery
3. starter motor
4. starting circuit cut-off relay
5. starter relay
6. main switch
7. engine stop switch
8. brake light switch (front and rear)
9. sidestand switch
10. start switch
11. wiring connections
(of the entire starting system)
TIP
8Before troubleshooting, remove the follow-
ing part(s):
1. battery box cover/front cover
2. seat/trunk
3. side cover (right)
4. leg shield 1
8Troubleshoot with the following special
tool(s).
Pocket tester
90890-03112 (YU-03112-C)
ELECTRIC STARTING SYSTEM
EAS00738
1.Main, signal and ignition fuses
8 Check the main, signal and ignition fuses for
continuity.
Refer to “CHECKING THE FUSES” in chap-
ter 3.
8 Are the main, signal and ignition fuses OK?
YES NO
EAS00739
2. Battery
8 Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
Minimum open-circuit voltage
12.8 V or more at 20°C(68°F)
8 Is the battery OK?
YES NO
8 Clean the battery
terminals.
8 Recharge or re-
place the battery.
Replace the fuse(s).
Downloaded from www.ScooterTime.net