User's Manual

3-24
CHK
ADJ
1
CHANGING THE ENGINE OIL
Quantity
Total amount
0.85 ~ 0.95L (0.9 ~ 1.0 US qt, 0.75 ~
0.84 Imp. qt)
Periodic oil change
0.80 ~ 0.90L (0.87 ~ 0.98 US qt, 0.74
~ 0.83 Imp. qt)
8. Install:
8engine oil filler cap
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
8engine
(for engine oil leaks)
11.Check:
8engine oil level
Refer to “CHECKING THE ENGINE OIL
LEVEL”.
T
R
.
.
12.Check:
8engine oil pressure
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the engine temperature sensor
coupler.
b. Slightly loosen the engine temperature sen-
sor 1.
c. Start the engine and keep it idling until en-
gine oil starts to seep from the engine tem-
perature sensor. If no engine oil comes out
after one minute, turn the engine off so that
it will not seize.
d. Check the engine oil passages, the oil filter
cartridge and the oil pump for damage or
leakage. Refer to “OIL PUMP” in chapter 5.
e. Start the engine after solving the problem(s)
and check the engine oil pressure again.
f. Tighten the engine temperature sensor to
specification.
Engine temperature sensor
18Nm (1.8m • kgf, 13.0ft • lbf)
g. Connect the engine temperature sensor
coupler.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Downloaded from www.ScooterTime.net