Instruction manual

INSTALLATION INSTRUCTIONS
YAMAHA
TOOLS NEEDED
- #1 Phillips Screwdriver
- 10 & 12mm Socket Wrench
- Needle Nose Pliers
- Less than 1 hour
Yamaha V Star 1300
Fuel Injected Models
INTRODUCTION: Congratulations on your purchase of the Fuelpak
Fuel Management System for fuel injected Yamaha V Star 1300
motorcycle. Please take the time to read the entire instruction manual
before attempting to install. DO NOT adjust the Fuelpak until you have
thoroughly read the instruction manual and the unit is fully installed. If
you have questions, please call [phone].
SUMMARY: To achieve the optimum performance from your
application, it is recommended that you install a high performance
air filter in conjunction with this unit. The Fuelpak will be installed
in-line the factory injector wiring harness and the throttle position sensor. The
Fuelpak will be tucked under the seat next to the tool tray.
1. Be sure the main switch is in the off position during
the installation process. Failure to do this will cause
the “check engine” light to be set.
2. Remove seat exposing the tool tray and battery.
3. Remove the (2) 12mm Hex head bolts securing rear of
tank. Prop up the rear of the tank.
4. Locate and unplug the white 4-pin connector under
left side of tank as shown in figure 1.
5. Route Fuelpak as shown in figure 2. Plug Fuelpak
white connectors to the factory connectors unplugged
in step 4.
6. Connect brown and green wires to the negative side
of the battery.
7. Route Fuelpak long black wire under right side of tank
and down to the horn as shown in figure 3.
Disconnect the factory black / white wire from horn.
Plug in Fuelpak long black wire to horn and then
connect factory black / white wire to terminal on
Fuelpak black wire.
8. Locate the throttle position sensor on the throttle
body located on right side of the tank. As shown in
figure 4, attach T-tap to yellow / black wire on throttle
position sensor. Connect Fuelpak violet wire to T-tap.
9. Using supplied Velcro, mount Fuelpak next to tool tray
as shown in figure 5.
10. Reinstall tank with (2) 12mm Hex head bolts removed
in step 3.
11. You are now ready to set-up your Fuelpak.
INSTALLATION INSTRUCTIONS FOR P/N 65003
READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION
FUEL INJECTION MANAGEMENT SYSTEM
V STAR 1300
NOTICE:
Fuelpak is intended for racing or off-highway
use only, and is not legal for sale or use in
California on pollution-controlled vehicles.
PLEASE NOTE: FUELPAK USE REQUIRES A HIGH PERFORMANCE AIR FILTER.
3
4
5
4-PIN CONNECTOR