manual

PM1D System Software V1.6 Supplementary Manual

In the CH 1-48/STIN 1-4 screen or the CH 49-96/STIN 5-8 screen, use the buttons of the METER BRIDGE area to select

the mode by which the meter bridge will display the input channel levels. You can choose FIXED CH mode or FOLLOW

PANEL mode. The display in the METER BRIDGE area and the operation of the meter bridge will change as follows,

according to the mode you choose.

PM1D Manager is not able to display input channel levels in the meter bridge. However, the PEAK HOLD button of

PM1D Manager will change to “IN PEAK HOLD” or “OUT PEAK HOLD” just as in the CS1D screen.

FIXED CH mode

When the FIXED CH button is on, the combination of input channels displayed in the meter bridge will always be ﬁxed.

• Horizontal pairing mode • Ve rtical pairing mode

Use the following buttons to select the combination that is displayed.

• button

(Selectable only if the FIXED CH button is on)

When this button is on, the meters will always display the levels of input channels 1–48 (if Vertical pairing mode is

selected, channels 1, 49, 2, 50…24, 72) regardless of the currently selected panel assignment or layer.

Horizontal pairing mode

Ve rtical pairing mode

At this time, the MIX/MATRIX bus number LED located at the bottom of the meter bridge will go dark. In the

METER section, the METER SELECT [MIX 25-48] switch will blink, and the [MATRIX 1-24] switch will go dark.

FIXED CH button is on

Selectable combination

FIXED CH button is on

Selectable combination

Input channels 1–24 Input channels 25–48

[Meter bridge]

················ ················

[Meter bridge]

Input channel 1

49 50 60

12 13

61 62