Owner's Manual

Chapter 5 Components
DME Designer Owner’s Manual
291
User Control Editor/User Module Editor Context Menu
The context menus that appear when you right-click in a window will differ in operation mode and in
design mode. In design mode, other commands will be added, depending on where you click.
The context menu for the user module editor contains the [Set User Module As Master Layout]
command.
■ Operation Mode
Commands that are displayed in the context menus for operation mode will also be displayed in
design mode.
[Design Mode]
Switches between design mode and operation mode. When you are in design mode, a checkmark
will appear to the left of the command name.
[Peak Hold]
Tur ns the peak hold meter ON or OFF and performs a reset. The ON or OFF setting for peak hold
applies to the whole zone.
• [On]
When you select this, peak hold is turned ON, and a checkmark appears next to it. If you
select this item while it is checked, peak hold is turned OFF.
• [Reset]
Resets peak hold.
[Close All Editor Windows]
Closes all component editor windows.
[Open Parameter Link]
Opens the “Parameter Link” window. For information about the Parameter Link window, see
“Parameter Link” (page 73).
NOTE
Peak hold is a function that makes it easy to see the maximum signal value by lighting up at the level of the
maximum value as the signal peak comes in.