Owner's Manual

Chapter 6 Component Guide

DME Designer Owner’s Manual

416

■ MY16-C

Double-click the block to display the component editor for it.

Section Parameter Setting Range Function

1 Setting Priority Setting Priority Hardware/

Software

The MY16-C switch settings take priority when

“Hardware” is selected, and the DME Designer

settings take priority when “Software” is

selected.

2 Bundle Number Input 0 to 65279 Sets the input bundle number.

Output 0 to 65279 Sets the output bundle number.

3 Serial Channel Rx OFF, 1 - 16 Sets the serial channel for the receive side.

Tx OFF, 1 - 16 Sets the serial channel for the send side.

4 Properties Bit Length Bit Off

16 bit

20 bit

24 bit

Sets the bit rate for output. Mutes the signal if

[Bit Off] is set.

5 Latency 5.33 ms

2.67 ms

1.33 ms

Sets the delay.

NOTE

The parameters will not link immediately when Setting Priority is switched.

Please edit another parameter after switching Setting Priority.

MY16-C R | [ l g G f B ^ [

MY16-C component editor