Owner's Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
73
Parameter Link
About Parameter Links
You can group parameters of the same type and link them. These groups are called “Parameter
Links.” When one parameter in a group is changed, all parameters in the group will change in the
same way.
There are two parameter link types: global links and local links. Global links link parameters for DMEs
within a zone. Local links link parameters that are included for a single DME.
Groups can be created and parameters added to groups in the user control/user module control
editor and component editor. For information about creating parameter links, see “Creating Parameter
Links” on page 314.
You can check the status of parameter links and edit them in the Parameter Link window.
Parameter Link Window
When you click [Parameter Link] in the [Tools] menu, the “Parameter Link” window is displayed. You
can also display the window by selecting [Open Parameter Link] from the context menu displayed in
the user control/user module editor and component editor.
1 [Global Link] button/[Local Link] button
Switches the window display.
Global Link
Links to the parameters of multiple DME units in the zone.
Local Link
Links to the parameters of one DME unit.
NOTE
Parameters can not apply to multiple groups.
NOTE
Because there is a large load on the network, the maximum number of Global Links will be limited to eight.
[Global Link] button/[Local Link] button
Parameter Link Mode