Installation guide

DME Designer Installation Guide 9
English
Windows 2000
1 Select [Start] → [Settings] → [Control Panel] → [Network
and Dial-Up Connections] → [Local Area Connection].
The “Local Area Connection Status” dialog box will be
displayed.
2 Click [Properties] on the [General] tab.
The “Local Area Connection Properties” dialog box will
be displayed.
3 Click [Internet Protocol (TCP/IP)] on the [General] tab,
then click [Properties].
The “Internet Protocol (TCP/IP) Properties” dialog box will
be displayed.
4 Click [Advanced…], then [Properties] on the [Options]
tab.
The “TCP/IP Filtering” dialog will be displayed.
5 Select “Permit All” for TCP Ports, then click [OK].
The display returns to the “Advanced TCP/IP Settings”
dialog. Click [OK] to return to the “Internet Protocol (TCP/
IP) Properties” dialog.
6 Click [Use the following IP address] on the [General] tab.
7 Enter your computer’s IP address into [IP address], the
Gateway's IP address into [Default gateway], and
“255.255.255.0” into [Subnet mask].
n When installing on the same subnet as the DME unit(s), set
the gateway's host address to 254.
8 Click [OK].
9 Restart your computer.
An example of four DME settings in a single area
The explanation in this example is based on both the zone and computer sharing the following IP address pattern:
“192.168.000.***.”
If you will be following the instructions in “Controlling from a Computer That Has the Same Network Address” on page 26 of
the “DME64N/24N Owner’s Manual,” you will need to make some changes to the network settings of your computer in
addition to the DME-N Network settings described on page 5.
For the first DME, “192.168.000.2” is set as the zone master IP address.
*1
For the second DME, “192.168.000.3” is set as a zone slave IP address.
*2
For the third DME, “192.168.000.4” is set as a zone slave IP address.
*2
For the fourth DME, “192.168.000.5” is set as a zone slave IP address.
*2
For the computer, “192.168.000.001” is set as the IP address.
*3
“255.255.255.0” is set as the subnet mask.
If the default gateway is not connected to an external network, there is no setting. If connected to an external network, set
“192.168.000.254”.
*4
Allow all TCP ports in TCP/IP filtering.
If you are using Windows XP, disable the Internet connection firewall setting.
*1 There are two zone master host addresses.
*2 Any address between 3 and 253 is a zone slave host address.
*3 For the IP address set on the PC, you can select host address 1 or 3 through 253, as long the one you set does not duplicate a DME address.
*4 The gateway host addresses is fixed as 254.