Owner's Manual

Chapter 3 Main Panel Window

DME Designer Owner’s Manual

140

EtherSound Connection

 Digital Mixers Without a [REMOTE] Connector

Use an EtherSound interface card such as the MY16-ES64 to make EtherSound connections between

the digital mixer and DME units. Use an Ethernet cable connected to the [NETWORK] connectors to

make connections between DME series units.

The port to be used for head amp control via direct serial communication with a DME unit is specified

by the [Internal HA Control] parameter in the “Remote” tab/“Remote V3.5” tab in the “Utility” dialog box

(page 168 or 173). Select “Slot 1” when the DME unit to be used for serial communication is a

DME24N, “Slot 3” or “Slot 4” if it is a DME64N, or “EtherSound” if it is a DME Satellite unit. The settings

for all other DME units should be “OFF”.

Use the AVS-ESMonitor software from AuviTran to specify the following EtherSound settings for both

the digital mixer’s interface card and the DME unit.

• Serial Communication mode: Unicast for bidirectional operation.

• AD8HR Remote Option: Mode 2

• Baud Rate: 38400

In order to turn serial communication off for the interface cards installed in all other DME units, set the

Serial Communication mode to “Slave”.

NOTE

• When installing an MY16-ES64 or similar EtherSound interface card in an LS9-32, be sure to install it in SLOT 1. Also

select “SLOT 1” using the COMM PORT parameter in the LS9 EXTERNAL HA display.

• DME24N units with firmware version V3.04 or later are compatible.

• You can download the AVS-ESMonitor software from the AuviTran website.

http://www.auvitran.com/

LS9

DME8i-ES

DME4io-ES

DME24N

Ethernet

EtherSound

MY16-ES64

Network

Switch

(mode 2)