Owner's Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
170
 MIDI Tab
Port
Selects the MIDI port to be used. If the selected terminal was previously assigned to a different
function, a confirmation dialog will appear. The available ports depend on the device.
DME64N: OFF, Remote(RS-232C), Remote(RS-422), MIDI, USB-1–2, Slot1–4
DME24N: OFF, Remote(RS-232C) , Remote(RS-422), MIDI, USB-1–2, Slot1
DME Satellite: OFF, Remote, USB-2
OFF: Select “OFF” when this function is not to be used.
Remote(232C): MIDI data will be received via the DME64N/24’s [REMOTE] connector using an
RS-232C connection.
Remote(422): MIDI data will be received via the DME64N/24’s [REMOTE] connector using an
RS-422 connection.
MIDI: The MIDI connector is the currently active MIDI port.
USB-1, USB-2: The corresponding USB port is selected for MIDI input.
Slot1–Slot4: A card installed in the corresponding I/O slot is currently selected for MIDI input.
Remote: The [REMOTE] connector of the DME Satellite is currently active MIDI port.
NOTE
If a DME unit in the Device List is running firmware version V3.5 or earlier, the corresponding MIDI tab will be grayed out
and cannot be selected.
NOTE
When “Remote” is selected for a DME Satellite unit, be sure to change the [REMOTE] connector setting (RS-232C or
RS422) via the rear-panel DIP switches.