Owner's Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
173
 Remote V3.5 tab
Internal HA Control
Specifies the port to be used for control of internal DME head amps from a PM5D or other
compatible console. The available ports depend on the device.
DME64N: OFF, Remote, Slot 1 through 4
DME24N: OFF, Remote, Slot 1
DME8i-C/DME8o-C/DME4io-C: OFF, Remote, CobraNet
DME8i-ES/DME8o-ES/DME4io-ES: OFF, Remote, EtherSound
Remote
Displays and allows editing of the DME unit [REMOTE] terminal. The following seven settings are
available:
HA Control (422): External head amplifier control (RS-422 only).
COM (232C): This is a Yamaha maintenance setting.
COM (422): This is a Yamaha maintenance setting.
MIDI (232C): MIDI command control via the [REMOTE] terminal (RS-232C).
MIDI (422): MIDI command control via the [REMOTE] terminal (RS-422).
Remote Ctrl (232C): Control using DME Remote Control Protocol via the [REMOTE] terminal (RS-232C).
Remote Ctrl (422): Control using DME Remote Control Protocol via the [REMOTE] terminal (RS-422).
Remote Control via Ethernet
Check this checkbox when a DME Satellite [NETWORK] connector is to be used for remote control
using DME remote control protocol. The Ethernet port to be used for remote control will be
displayed in the “IP Port No.” field. Change the port as necessary via the “Select IP Port No.” dialog
box that appears when the [Select IP Port No.] button is clicked.
Since the DME Satellite network connection will automatically be broken when the port is changed,
DME Designer will have to be re-launched.
NOTE
Can only be selected when the DME unit selected in the Device List is running firmware version V3.5 or earlier.
NOTE
An ID must be assigned to the DME unit to be controlled. Refer to “Setting the Internal Head Amp ID ” (page 142) for
details on assigning device IDs.
NOTE
Does not apply to DME64N/24N (V3.5 or earlier), SP2060, and ICP1 units.
NOTE
Uncheck the checkbox when the [REMOTE] connector is to be used for remote control.