Owner's Manual

Chapter 3 Main Panel Window
DME Designer Owner’s Manual
182
Backup
When you click the [Backup] command on the [Hardware] menu, the “Backup” dialog box is
displayed. Data in the DME or SP2060 is gathered in the computer and saved as a file. Backup files
are created for each DME or SP2060. You can also send the information saved in a file to a DME or
SP2060. Backup can be performed only when in offline status.
 [Target DME]
The DME and SP2060 IP addresses and types are displayed for each device group. Check the
DME and/or SP2060 units from which data is to be obtained. Multiple DME and SP2060 units can
be checked.
 [Folder] Box
Specifies the folder that will be the destination for saving and reading operations. Clicking the
[Browse] button opens the folder select dialog box, where you can specify a folder.
The backup file name will be the DME’s IP address. If the folder is specified when sending DME
data, the file sent to the DME will be the file in the folder whose file name that matches the DME’s IP
address.
 [Load] Button
Sends the backed up file to the specified DME or SP2060.
 [Save] Button
Obtains data from the specified DME or SP2060, and saves it as a backup file.
 [Close] Button
Closes the dialog box.
NOTE
If a backup file from a DME unit running firmware version V3.8 or later is loaded into a DME unit running a firmware version
earlier than V3.5, the Remote and MIDI control settings will not apply (all other settings will apply).
NOTE
Backup operations can be performed only by users for whom the [Edit] security checkbox has been checked.
NOTE
The event log can be retrieved from the DME unit in the “Event Logger” window.