Owner's Manual

Chapter 4 Designer
DME Designer Owner’s Manual
300
Placing Components
You can place objects by dragging them from the Toolkit window. You can also place objects by
double-clicking them in the Toolkit window. The same objects are displayed in the [Component List]
submenu on the [Tools] menu or on the context menu that appears when you right-click on the sheet.
For information about the [Component List] in the Configuration window, see page 199.
 Arranging a Number of Components of the Same Type
You can arrange a number of components of the same type. If there are two or more of the same
component, numbers will be attached to their names as follows: “Compressor (2),” “Compressor
(3)” and so on. Multiple components placed in the configuration are independent, and you can set
different parameters for each of them.
NOTE
The components that can be placed in the configuration window vary according to the device type. For details, see
“Component List” on page 370.
NOTE
If the [Matrix Mixer 64 input 64 output] or the [Matrix Mixer 64 input 32 output] components are placed in the DME64N
configuration window, you will not be able to use other components, even though the window does not reach 100 percent.
The [Matrix Mixer 64 input 64 output] or [Matrix Mixer 64 input 32 output] components cannot be used in the DME24N and
DME Satellite.