Owner's Manual
Chapter 6 Component Guide
DME Designer Owner’s Manual
485
Analog Input and Output
In the DME24N/DME Satellite configuration window, there are [Analog Input] and [Analog Output]
blocks.
Analog Input
Right-click the component and select [Open HA Editor] from the contextual menu to open the
editor.
Either double-click the component, or select [Open Input Component Editor] from the contextual menu
that appears when the component is right-clicked to open the component editor.
Caution
• If you don’t need phantom power, be sure to turn this button off.
• Before you turn phantom power on, make sure that no equipment other than phantom-powered devices
such as condenser microphones are connected to that jack. Otherwise, you risk damaging your external
equipment. Balanced dynamic microphones, however, will not be affected by phantom power.
• Do not connect or disconnect a device to [IN]/[INPUT] jacks while phantom power is applied. Doing so
can damage the connected device and/or the unit itself.
• To protect your speaker system, leave the power amps (powered speakers) turned off when switching the
phantom power on/off. We also recommend that you set all output levels to minimum. Otherwise, high-
volume output may damage your hearing or equipment.
NOTE
The DME24N, DME8i-C, DME4io-C, DME8i-ES and DME4io-ES have analog inputs. The DME24N, DME8i-C and DME8i-ES
have eight analog inputs, while the DME4io-C and DME4io-ES have four.
Parameter Setting Range Function
1
+48 ON/OFF Turns ON phantom power (+48V).
2
Gain +10 to -60 dBu Sets the rated input level.
1
2