Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
6-13
6
be operated without the air filter
element installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
[ECA10481]
5. Install the air filter case cover by in-
stalling the screws.
Cleaning the air filter check hoses
1. Check the hoses on the rear side
of the air filter case for accumulat-
ed dirt or water.
2. If dirt or water is visible in the air fil-
ter check hoses, remove the
clamps from them, and then re-
move the plugs to drain the hoses.
Cleaning the V-belt case air filter el-
ement
1. Place the scooter on the center-
stand.
2. Remove the screws, and then pull
the V-belt case air filter element
cover outward and away from V-
belt case.
3. Remove the V-belt case air filter
element holder by removing the
screw.
4. Pull the V-belt case air filter ele-
ment out, and then clean it with
solvent. After cleaning, remove the
remaining solvent by squeezing
the element. WARNING! Use
only a dedicated parts cleaning
solvent. To avoid the risk of fire
or explosion, do not use gaso-
line or solvents with a low flash
point.
[EWA10431] NOTICE: To avoid
damaging the air filter element,
handle it gently and carefully,
and do not twist it.
[ECA10521]
1. Air filter check hose
2. Clamp
3. Air filter check hose plug
1
2
3
1. V-belt case air filter element cover
2. Screw
2
1
1. V-belt case air filter element holder
2. Screw
1
2
U4P7E2E0.book Page 13 Thursday, August 20, 2009 9:44 AM