Owner`s manual

31
Getting Started
●
Setting Up
Setting Up
4. Select “Load From Disk”
Use the cursor buttons to move the cursor to “2:Load From Disk” and then
press [.
5. Select “All” and Select the “001:NOBREATH:ALL” File
Make sure the cursor is positioned at “1:All” and press [.
When the list of files appears select the “001:NOBREATH:ALL” file, then press
[ again.
NOTES ■ The “001:NOBREATH:ALL” file contains voices that are programmed to
be played without a breath controller. If you will be using a breath controller or
MIDI Wind Controller you might want to load one of the other files supplied on
the VL1-m data disk: see “About the VL1-m Data Disk”, below.
6. Load the File
Loading will begin when you press the - button in response to the “Are You
Sure?” prompt. A bar graph on the display will indicate the progress of the load opera-
tion, and when all the data has been loaded “Completed!” will appear.