Owner's Manual

120
Feature Reference
●
Edit Mode
3-1: Equalizer Auxiliary HPF Key Scaling
Equalizer HPF key scaling produces natural tone variations across the range of the
keyboard by allowing different cutoff frequency offset values to be applied to each of
three breakpoints set at appropriate keys.
• The ¶ button (“Fpag”) can be used to go directly forward to the next
equalizer auxiliary key scaling page without having to return to the main
parameter page.
● HPF
≤ 17.0 Hz … 11.2 kHz.
The “HPF” parameter is linked to the main equalizer auxiliary “HPF Cutoff
Freq.” parameter, and sets the cutoff frequency of the high-pass filter. Frequency
components below the specified frequency are cut off. This value also determines the
main cutoff frequency on which all key-scaled variations are based (indicated by a dotted
line on the graph).
● Breakpoint 1 … 3 Key
≤ C-2 … G8.
Allows three separate key scaling breakpoints to be set at any notes between C-2
and G8. You can position the cursor at the appropriate breakpoint key parameter and use
any of the normal data entry procedures, or use a keyboard. To use a keyboard for
breakpoint entry, position the cursor at the appropriate breakpoint key parameter, press
the • button (“Kbd”), and then press the key at which you want to set the breakpoint
while “Kbd” appears in inverse characters.
No breakpoint can be set to a key lower than the breakpoint to its left.
● Breakpoint 1 … 3 Offset
≤ -64 … 63.
Set the amount of cutoff frequency offset for each of the breakpoints defined by the
breakpoint key parameters, above. Negative values lower the cutoff frequency, and
positive values raise the cutoff frequency at the corresponding breakpoint. No matter
what offset value is chosen, the actual cutoff frequency will never exceed its minimum or
maximum absolute value. When different offset values are applied to adjacent break-
points, the cutoff frequency varies smoothly between the breakpoints.