Owner's Manual

Feature Reference

●

Edit Mode

site effect: the sound changes dramatically at low controller values while higher values

produce relatively little effect. The “Curve” setting is reflected in the graph to the right

of the parameters — the horizontal axis represents the controller value and the vertical

axis represents filter cutoff frequency.

• No dynamic filter frequency variation can be applied via any controller if the

ELEMENT MODIFIER Dynamic Filter page “Balance” parameter is set to

“-64” (≥ Page 116).

12: Harmonic Enhancer

• The § and ¶ buttons (“Bpag” and “Fpag”) can be used to go directly

backward or forward to the next Element Controller page without having to

return to the directory.

• The • button (“Para”) can be used to go directly to the Harmonic En-

hancer parameter page (≥ Page 107), also available from the ELEMENT

MODIFIER directory. You can then return to the controller Harmonic En-

hancer page by pressing • (“Ctrl”) again.

●

Controller

≤ off, Modulation Wheel … Touch EG (124 settings).

The Harmonic Enhancer can vary the harmonic structure of the sound over a wide

range. The “Controller” parameter specifies the controller to be used for harmonic

enhancer depth (wet/dry balance) control. When set to “off” no harmonic enhancer

depth variation can be applied via a controller.

●

Depth

≤ -127 … 127.

Sets the amount of variation produced by the controller assigned to the harmonic

enhancer. The higher the value the greater the variation. Positive values cause an increase

in harmonic enhancer depth in response to higher controller values (e.g. increased breath

pressure or higher modulation wheel position), while minus values cause a decrease in

harmonic enhancer depth in response to higher controller values. The “Depth” setting is

reflected in the graph to the right of the parameters — the horizontal axis represents the

controller value and the vertical axis represents harmonic enhancer depth depth.