Owner's Manual

Feature Reference

●

Edit Mode

13: Damping

• The § and ¶ buttons (“Bpag” and “Fpag”) can be used to go directly

backward or forward to the next Element Controller page without having to

return to the directory.

●

Controller

≤ off, Modulation Wheel … Touch EG (124 settings).

Simulates the effect of damping due to losses within the body of a wind instrument

or in a string due to air friction. Affects both pitch and timbre. The “Controller”

parameter specifies the controller to be used for damping control. When set to “off” no

damping variation can be applied via a controller.

• Please note that accurate keyboard pitch is produced only when damping is

maximum.

●

Depth

≤ -127 … 127.

Sets the amount of variation produced by the controller assigned to damping. The

higher the value the greater the variation. Positive values cause a decrease in damping in

response to higher controller values (e.g. increased breath pressure or higher modulation

wheel position), while minus values cause an increase in damping in response to higher

controller values. The “Depth” setting is reflected in the graph to the right of the param-

eters — the horizontal axis represents the controller value and the vertical axis represents

damping.

●

Curve

≤ -16 … 16.

Determines the relationship between the controller value and damping. When set to

“0” the relationship is linear. That is, a change in the controller value produces a corre-

sponding change in damping. As the curve value increases the lower end of the controller

range has relatively little effect on the sound while higher controller values produce more

dramatic changes. Negative curve values have the opposite effect: the sound changes

dramatically at low controller values while higher values produce relatively little effect.

The “Curve” setting is reflected in the graph to the right of the parameters — the

horizontal axis represents the controller value and the vertical axis represents damping.