User Manual

13
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
Installing in a ceiling (using the CMA3S)
You can use the optional VXS3S ceiling mount adaptor to install the
speaker in a ceiling.
1
Cut a hole in the ceiling
1-1
Use the included cutout template (350mm×210mm) to mark the
outline of the hole on the ceiling.
NOTE
Make sure to use the included cutout template; if the hole size is not correct, you
will not be able to install the speaker.
1-2
Cut along the outline and cut the hole.
When cutting the hole, be careful to prevent debris or dust from
entering your eyes.
2
Attach the square ring and rails to the inside
surface of the ceiling.
2-1
Insert the two tile rails through the cut hole and place them on the
ceiling surface within your reach. Be sure that each tile rails are
oriented as shown in the illustration.
2-2
Insert the square-ring through the cut hole.
2-3
Secure the square-ring and tile rails with supplied two screws
through either slot of both square-ring brackets.