User Manual

6
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
Connections
Set the line voltage/impedance and power
Select the line voltage/impedance (100V/70V/8
Ω
) and input wattage
power tap when using a 100V/70V line distributed system.
Satellite speakers (NONE)
Satellite speakers (×4)
Satellite speakers (×2)
NOTICE
• When connecting speakers with high impedance, check the tap selector switch
settings indicated around the switch, and then set the tap according to the number of
satellite speaker connections (NONE/×2/×4) and the output (W).
Make sure that the input total of each speaker does not exceed the rated output of the
power amplifier.
• Do not set the tap selector switch to the "X" position.
• When using a low impedance connection, set the tap selector switch to the “8
Ω
”
position.
If the setting is incorrect, it may cause malfunction of the speaker and amplifier.
• Make sure the amplifier is switched off before operating the tap selector switch.
Connect the power amplifier and the VXS3S
Connect the OUTPUT of the power amplifier to the INPUT of the
subwoofer.
＋
－
Power amplifier
INPUT
INPUT